When drilling a ball you want to know your pin like how long is your pin. with a pin placement you wanna place the pin where the ball with give you the best feel, but you wanna check out the specs of the ball,

 for example i buy a Lane 1 cobalt  bomb pearl, with a 1.5 inch pin, i drilled the pin in between the finger because i know that gives me the most control but buy putting the pin there it took alot of hook off the ball and gave it backend, i bought another coblat and drilled it under my ring finger and that gave me alot more hook over all.

  So when you drill a ball try to drill it so you get a good feel on the ball, for you beginers out there.

In videos coming soon i will be throwing two new cobalt bombs, 15lbs each, with different pins placements and using the same pins. I will be showing the difference in pin placements on a bowling balls.

 If you wanna see me throw a bowling ball that you wanna buy, just leave a comment and ill try to make a video of it so you can see it before you get it. Thanks

Pin Placement is a very important thing that helps your ball pretty much do any thing.

Where do you want your pin placement at?????

For Oily lanes you want the pin far away from your track. (your track is the part where the ball rolls on the lane)
In the picture below it shows for a righty where you want your pin, where the pin=p and your track=T. Now if you have a high rev rate and you want extra length on the ball get closer to your track, but make sure not to get to close to it. You would want the pin to be above the fingers or if you want length and a smooth roll on it you would want it below your fingers.

The higher the pin the sharper the reaction and the lower the smoother the reaction.